A drone flight time calculator estimates how many minutes a drone can stay in the air on one battery. It uses the battery capacity, the share you are willing to use, the voltage and the all-up weight, and it also shows shorter times for windy or fast flying.
How to use the drone flight time calculator
- Choose US or metric units for the weight.
- Enter the battery capacity, in Ah or mAh, and the voltage.
- Enter the all-up weight.
- Change the usable share or power per kilogram if you wish, then press Calculate.
The two formulas
We estimate the flight time as the battery capacity times the allowed discharge, divided by the average amp draw, and the average amp draw as the all-up weight times the power per kilogram, divided by the battery voltage. Both steps are our own working from energy and power. The result is first in hours, and the tool multiplies by 60 to give minutes. The method assumes mostly hovering, in which the drone uses a steady amount of power to stay up. A published multirotor sizing study makes the same assumption: in hover the thrust equals the weight, and a constant power discharge represents the use of battery energy well [1].
Battery capacity and voltage
Battery capacity is given in ampere hours, Ah, or in milliampere hours, mAh, which is a thousandth of an Ah. The tool takes either, and divides by 1,000 when you choose mAh, which is our own conversion. The voltage of the pack is printed on the label, and depends on the number of cells in series. There is no default for either value. The capacity and voltage are needed in the estimate, and a bigger pack of the same weight will fly longer.
Usable share of the battery
We use 80 percent of the battery as the default, which is our own planning assumption. Lithium polymer cells should be protected by a circuit that does not let them over-discharge [2], so leaving some charge protects the cells and keeps a reserve for landing. We treat it as the allowed discharge. You can change it, for example to 70 for a more careful flight. The share must be above zero and no more than 100. If the box is empty, the tool uses 80.
Power per kilogram
We use 170 watts per kilogram as a conservative default and 120 watts per kilogram for an efficient system. Both are planning figures of our own, not values taken from a source. This is the power that the drone needs per kilogram of weight to hover. In our own words, a heavier or less efficient system needs more. If you know the real hover power, you can calculate the watts per kilogram yourself and enter it. The tool uses 170 when the box is blank.
Worked example
A battery of 8.8 Ah at 36 volts, with 80 percent usable and a drone of 2.5 kilograms at 170 watts per kilogram, gives an average draw of 2.5 times 170 divided by 36, which is 11.806 amps. The flight time is 8.8 times 0.8 divided by 11.806, which is 0.5963 hours, or about 35.8 minutes. Rounded, that is about 36 minutes. In the same example the usable energy is 253.44 watt hours at a power of 425 watts.
An energy view
We also show the usable energy and the average power. The energy is the capacity times the voltage times the usable share, here 253.44 watt hours. The average power is the current times the voltage, here 425 watts, which is also 2.5 kilograms times 170 watts per kilogram. Energy divided by power gives the same time as the first method, because the two ways are algebraically the same. This view is our own working. It helps if you think in watt hours, as many battery labels do.
Time for different flying styles
We show rough shares of the hover time for other kinds of flying. In forward flight the rotor power rises with speed [1], which is why moving flight is shorter than hover. For gentle photography, about 75 percent of the hover time, 26.8 minutes in the example. For strong wind or a lot of movement, about 50 percent, which is 17.9 minutes. For FPV racing or flying at high throttle, 25 to 30 percent, 8.9 to 10.7 minutes. These factors are our own rules of thumb, not formulas or published measurements, and the tool shows them for comparison. Your own flights will vary.
US or metric weight
In US mode, you enter the weight in pounds, and the tool converts it to kilograms by multiplying by 0.45359237, our own conversion, because the power figure is in watts per kilogram. In metric mode you enter kilograms directly. The power per kilogram stays in watts per kilogram in both modes, so that the defaults from the page apply unchanged. Include the battery, the camera and any payload in the all-up weight.
Entering the current yourself
If you have measured the average current, from a flight log or a power meter, enter it in the last box. The tool then skips the estimate from the weight and the power per kilogram, and divides the usable capacity by your current. The weight is then not needed. The voltage is also optional in this case, and it is only used to show the energy and the power. A measured current is usually better than the estimate, since it reflects your own drone.
What the estimate leaves out
The estimate assumes mostly hovering. It does not account for the age of the battery, for temperature, for the payload apart from its weight, or for wind apart from the rule-of-thumb factors. Treat the result as a planning figure, plan your flights with a margin, and land with some charge left. Follow the rules for your area on where and how you may fly.
Common mistakes
- Using mAh as Ah. Choose the unit, or divide by 1,000.
- Leaving out the battery from the weight. The all-up weight includes the battery.
- Using the hover time for a windy flight. Use the shorter times for movement.
- Planning to use all of the battery. Keep a reserve for landing.
What next
Use this often? Add Drone Flight to your Home screen.
Frequently asked questions
What is a drone flight time calculator?
It is a tool that estimates how long a drone can stay in the air on one battery, from the capacity, voltage and all-up weight.
How is drone flight time calculated?
The average amp draw is the all-up weight times the power per kilogram divided by the voltage. The flight time is the battery capacity times the usable share divided by that current.
What power per kilogram should I use?
We use 170 watts per kilogram as a conservative default and 120 for an efficient system. Both are planning figures, and you can enter your own value.
Why is the usable share 80 percent?
We assume 80 percent, which keeps a reserve and is easier on lithium polymer cells. You can change it.
Is the result the real flight time?
No. It is an estimate for mostly hovering flight. Wind, payload, cold and battery age shorten it, so keep a reserve.
Sources
Was this tool helpful?
What went wrong?
We only receive the reason you pick, never what you typed into the tool.
Thanks for your feedback.