Saved

Press the star next to a tool's name to save it.

All my tools

Evaporation Rate Calculator

Use this evaporation rate calculator to estimate how much water a pool, pond or tank loses per hour and per day from its surface area, air speed, water temperature and humidity.

Restored your last values ·

%
hours

Choose US or metric units. Enter the water surface area, the air speed over it, the water surface temperature and the relative humidity of the air. Add hours to get the water lost over that time.

Everything is worked out in your browser. Nothing you type is sent anywhere.

–

–

Enter the area, air speed, water temperature and humidity, then press Calculate.

See full result

An evaporation rate calculator estimates how much water a pool, pond or tank loses from its surface. Enter the surface area, the air speed over the water, the water temperature and the relative humidity. It gives the loss per hour and per day, and a total for any number of hours.

How to use the evaporation rate calculator

  1. Choose US or metric units.
  2. Enter the area, air speed, water temperature and humidity.
  3. Add the hours if you want a total.
  4. Press Calculate.

The empirical formula

The hourly loss is g = (25 + 19 v) × A × (Xs − X) kilograms per hour. Here v is the air speed in metres per second, A the surface area in square metres, Xs the saturated humidity ratio of air at the water temperature and X the humidity ratio of the actual air, both in kilograms of water per kilogram of dry air [1]. The factor 25 + 19 v is an evaporation coefficient in kilograms per square metre per hour that grows with the wind [1]. This is the humidity-ratio form of a Carrier-type equation. Formulas of that family are curve fits to measured data, and many take the form of a coefficient B, which may equal C1 + C2 V with V the air velocity, times the difference in vapor pressure between the water surface and the air [2].

Where the humidity ratio comes from

The source defines Xs as the humidity ratio of saturated air at the same temperature as the water surface [1], but it gives no formula for it. The calculator uses a cubic polynomial of our own, Xs = 3.733 × 10⁻³ + 3.2 × 10⁻⁴ T + 3 × 10⁻⁶ T² + 4 × 10⁻⁷ T³, with T the temperature in degrees Celsius. We have not checked it against a published psychrometric table, so treat it as an approximation. It is not guaranteed below 0 °C or above 30 °C, and the calculator adds a warning in that case.

The role of humidity

The actual humidity ratio is the relative humidity times the saturated value, X = RH ÷ 100 × Xs. Relative humidity is the percentage of the maximum humidity that the air holds, and this definition is our own working. Dry air makes the difference Xs − X large and the water evaporates fast; at 100 percent, the difference is zero and so is the loss.

A worked example with a pool

Take a pool of 30 by 15 feet, which is 41.8 square metres, with a wind of 3 mph, or 1.341 m/s, a water temperature of 82 °F, or 27.8 °C, and a humidity of 80 percent, our own example values. Then Xs = 0.02354 and X = 0.01883. The coefficient is 25 + 19 × 1.341 = 50.48 and the loss is 50.48 × 41.8 × 0.004706 = 9.93 kg per hour, about 22 pounds. Over six hours that is about 60 litres.

A garden pond

Take a garden pond of 1.86 square metres with a wind of 2.235 m/s, water at 20 °C and 70 percent humidity. The coefficient is 67.47 and the humidity gap is 0.00436, so the loss is about 0.55 kg per hour. Put these values in the metric mode and you get the same figure, which is a good check of the calculator.

Where the formula comes from

An overview of pool evaporation says that the best known formula of this kind is that of Carrier from 1918, and that the version in the ASHRAE Handbook is an adaptation based on Carrier's own tests on an unoccupied pool across which air was blown [2]. The same paper says that the velocity varies a lot from point to point over a pool, so it is not clear how the air speed should be measured [2]. Because the formula is empirical, we call the result an estimate.

From kilograms to litres

The calculator treats one kilogram of water as about one litre, which is our own simplification, and gives pounds and US gallons with standard conversions that are also our own working. Eight kilograms an hour sounds small, but over a day it adds up to hundreds of litres for a large pool, and the day figure is 24 times the hourly value at the same conditions.

Daily figures need averages

The daily result multiplies the hourly loss by 24. The calculator uses the single set of values that you enter, so for a better daily estimate, enter averages of the temperature, humidity and wind.

What the formula leaves out

The formula is empirical, a Carrier-type equation obtained by curve fitting to measurements [2], and gives an approximate figure. It has no terms for sunshine, a pool cover, swimmers, splashing, or whether the pool is indoors, which are our own remarks. Real losses can differ a lot from the estimate. Use the number to compare cases, such as a windy and a calm day, or to plan the top-up of a pond, and not as an exact value.

Using the calculator

Pick your units, fill in the four conditions and press the button. The water temperature sets the saturated humidity, and the relative humidity is that of the air above the pool.

Cutting the loss

Because the loss grows with the air speed and falls as the humidity rises, anything that lowers the wind over the surface or the temperature of the water helps. A cover keeps the humid air next to the water and stops the wind, a windbreak slows the air, and a cooler pond loses less. These are general remarks of our own, not statements of the sources, and the formula has no term for a cover, so use the calculator to compare calm and windy days and judge the size of the effect yourself.

Common mistakes

  • Entering the air temperature as the water temperature. The water surface sets Xs.
  • Using a percentage as a fraction. Enter 80, not 0.8.
  • Trusting a daily figure from a single reading. Use averages.
  • Using it far below 0 °C or above 30 °C. The polynomial is not guaranteed there.

What next

Use this often? Add Evaporation to your Home screen.

Frequently asked questions

What is an evaporation rate calculator?

A tool that estimates the water lost from a surface by evaporation, from the area, wind speed, water temperature and humidity.

What is the formula for evaporation from a water surface?

g = (25 + 19 v) × A × (Xs − X) kilograms per hour, with v in metres per second and A in square metres.

How much water does a pool lose a day?

For the example pool of 41.8 square metres, about 9.9 kg per hour, or about 238 kg over 24 hours at the same conditions.

What temperature range does the formula cover?

The polynomial for the saturated humidity is not guaranteed below 0 °C or above 30 °C.

Is the result exact?

No. The equation is empirical and approximate and has no terms for sun, covers or swimmers.

What went wrong?

We only receive the reason you pick, never what you typed into the tool.

Thanks for your feedback.

More Everyday Life Tools