The concrete driveway cost calculator estimates what a new concrete driveway will cost. Enter its length, width and thickness, then the prices you’ve been quoted: concrete per cubic yard, labor and finishing per square foot, reinforcement per square foot and any one-off costs such as removal of the old driveway. It shows how much concrete the job needs, the cost of each part, the total and the cost per square foot, alongside the typical national range. A 24 × 20 ft two-car driveway, 4 inches thick, uses about 5.93 cubic yards of concrete.
How much does a concrete driveway cost?
LawnStarter’s 2026 cost guide puts a new concrete driveway at about $6 to $16 per square foot installed, or $1,885 to $6,475 for most projects, with an average of about $3,500. Simple rectangular driveways with a plain broom finish sit at the low end; curves, slopes, decorative finishes and heated slabs push the price up. The calculator shows that $6–$16 range for your driveway’s area, so you can see whether a quote is in line.
The calculation
- Area = length × width (sq ft)
- Concrete volume = area × thickness (in) ÷ 12 ÷ 27 (cubic yards), plus any extra percentage you add for spillage and uneven ground
- Concrete cost = cubic yards × price per cubic yard
- Labor and finishing = area × price per sq ft
- Reinforcement = area × price per sq ft
- Total = the sum, plus any one-off costs
How to use the concrete driveway cost calculator
- Choose US or metric units.
- Enter the length and width of the driveway. Split an L-shaped or curved driveway into rectangles and add the results.
- Enter the thickness. If you leave it blank, the calculator uses 4 inches (10 cm).
- Add extra concrete if you want to order a little more than the exact volume.
- Enter the prices you have. Any you leave blank are left out of the total.
Worked example: a two-car driveway
A driveway 24 ft long and 20 ft wide, 4 inches thick, with concrete at $150 per cubic yard, labor and finishing at $4 per sq ft and wire mesh at $1 per sq ft:
- Area: 24 × 20 = 480 sq ft
- Concrete: 480 × 4 ÷ 12 ÷ 27 = 5.93 cubic yards, costing $888.89
- Labor and finishing: 480 × $4 = $1,920
- Reinforcement: 480 × $1 = $480
- Total: $3,288.89, or $6.85 per sq ft
The prices are only for the example. At LawnStarter’s typical $6–$16 per sq ft, the same driveway would cost $2,880 to $7,680 installed.
What affects the price
- Size and thickness. LawnStarter notes that adding 2 inches of thickness can raise the cost by about 25%.
- Reinforcement. Rebar or wire mesh adds about $1 to $3 per sq ft, and LawnStarter calls it a must for driveways that carry heavy vehicles or sit on a slope.
- Finish. Standard gray concrete is the cheapest at about $4–$6 per sq ft; stained runs about $6–$12 and stamped about $8–$15.
- Site work. Grading can range from $100 to $3,400, excavation from $500 to $6,000, and removing an old driveway typically $1,500 to $2,500.
- Shape. Circular, curved and L-shaped driveways take more labor and formwork than a rectangle.
Getting accurate quotes
Ask two or three contractors for written quotes that list the thickness, the concrete strength, the base preparation, the reinforcement, the finish and whether removal and permits are included. Then enter each quote’s figures here to compare them on the same basis. A quote far below the typical range may leave out base work or reinforcement that a driveway needs to last.
Doing part of the job yourself
Pouring a driveway is heavy, time-sensitive work, and most homeowners hire a contractor for it. Some save money by doing the demolition or site clearing themselves. If you’re pricing the concrete alone, enter only the concrete price and use the concrete calculator to check the number of bags for small sections. For a gravel base, the gravel calculator works out the stone. If you plan to mix concrete on site, the cement calculator works out the cement bags, sand and aggregate.
Concrete driveway size guide
LawnStarter’s guide gives typical totals by size: about $600 to $1,600 for a one-car driveway, $1,200 to $3,200 for a two-car driveway and $3,460 to $9,220 for a three-car driveway. Measure your own driveway rather than relying on a size label, as lengths vary a lot from house to house. Include the apron where the driveway meets the street and any parking pad or walkway that will be poured at the same time.
Concrete or another material?
The same guide puts a typical asphalt driveway at about $5,000, a gravel driveway at about $1,500 and a paver driveway at about $13,000. Concrete usually lasts longer than asphalt and needs little upkeep, but it can crack in freeze-thaw climates. Gravel is the cheapest to install but needs topping up. Weigh the upfront price against how long you plan to stay and the climate where you live.
Metric units
In metric mode, enter the size in meters and the thickness in centimeters. Concrete is priced per cubic meter and the other costs per square meter, and the result is shown without a currency sign so you can use any currency. The typical US range is shown only in US mode.
This is an estimate for planning, not a quote. Prices vary by region, season and site conditions.
What next
Use this often? Add Concrete Dri to your Home screen.
Frequently asked questions
How does the concrete driveway cost calculator work?
It works out the area and the concrete volume from the size and thickness, prices the concrete per cubic yard and the labor and reinforcement per square foot, and adds any one-off costs.
How much does a concrete driveway cost per square foot?
LawnStarter’s 2026 guide puts most new concrete driveways at $6 to $16 per square foot installed.
How much concrete do I need for a two-car driveway?
A 24 × 20 ft driveway 4 inches thick needs about 5.93 cubic yards, before any extra for spillage.
Does a concrete driveway need rebar or mesh?
Reinforcement adds about $1 to $3 per sq ft and is strongly advised for heavy vehicles or sloped driveways.
Was this tool helpful?
What went wrong?
We only receive the reason you pick, never what you typed into the tool.
Thanks for your feedback.