An arrow FOC calculator works out the front of center of an arrow, which shows how far the balance point lies in front of the middle of the shaft. Enter the length of the arrow and the distance from the nock to the balance point, and the calculator gives the FOC as a percentage. It uses the standard FOC formula that archery suppliers publish [1], and it works in your browser.
How to use the arrow FOC calculator
- Measure the length of the arrow (A).
- Find the balance point by resting the arrow on your finger or a knife edge until it balances, and measure its distance from the throat of the nock (B).
- Enter both lengths in the same units, for example inches or centimeters.
- Press Work out the FOC.
The formula
The front of center is the distance to the balance point minus half the arrow length, divided by the arrow length, times 100. The balance point is measured from the throat of the nock, and the arrow length runs from the nock throat to the end of the shaft [1]. In our first worked example, a hunting arrow is 30 centimeters long and balances 18 centimeters from the nock. Half the length is 15, so the balance point is 3 centimeters in front of the middle, and 3 divided by 30 gives an FOC of 10 percent. In a second example, a 30 centimeter arrow that balances at 20 centimeters has an FOC of about 16.7 percent. The calculator gives both results. For comparison, Lancaster Archery gives an FOC of 12 percent for a 29-inch Easton arrow with a 100-grain point [1].
What FOC means
A balance point at the exact middle of the arrow gives an FOC of zero. When the balance point is in front of the middle, toward the point, the FOC is positive. A higher FOC means that more of the arrow's weight is near the tip. This weight is mostly the point and the front of the shaft, and adding point or insert weight is the usual way to raise the FOC. A heavier point can improve penetration, but it also slows the arrow, which increases its arc, and it calls for a stiffer spine to support the extra weight [1]. There is no single simple answer for the ideal value, so test any change with your own bow.
Typical ranges
Easton Archery recommends a minimum FOC of 10 to 15 percent, and Lancaster Archery says this range applies to both target arrows and hunting arrows [1]. The same source notes that many bowhunters aim for 20 percent or a little more by adding insert or point weight, and presents this as optional [1]. The calculator therefore shows whether your result lies below, in or above the 10 to 15 percent range, and leaves the rest to your judgment and to your coach. Claims that a particular FOC always gives better accuracy or speed are not backed by a source here, so test any change with your own bow.
Measuring the balance point
Use a straight arrow with the point and nock fitted, as you would shoot it. Lay it across a narrow edge, such as a ruler, a pencil or a knife edge, and move it until it stays level. Mark that spot and measure from the throat of the nock, the part that is closest to the string, to the mark. A small error in this length makes a big change in the result, so measure carefully and repeat.
Worked example for a longer arrow
A 28-inch arrow balances 16 inches from the nock. Half the length is 14, so the balance point is 2 inches forward, and the FOC is 2 divided by 28, which is about 7.1 percent. That is below the common hunting range, and an archer who wants more could use a heavier point. A 29-inch arrow that balances at 18 inches has 3.5 inches of forward balance and an FOC of about 12.1 percent. These numbers are our own illustration.
Changing the point weight
The usual way to raise the FOC is to use a heavier point, and the usual way to lower it is to use a lighter one. Since the arrow's total weight changes too, the arrow will fly differently, and it may need a change to the spine or the length. If you experiment, change one thing at a time, and check how the arrow flies at the distances that you use. Ask an archery shop for advice before you cut or change your arrows, because a wrong combination can be unsafe or fly badly.
Why the length matters
The FOC is a share of the arrow's length, so the same balance point gives a different result on a longer or shorter arrow. A 30 centimeter arrow with a balance point 3 centimeters ahead of the middle has an FOC of 10 percent, while a 60 centimeter arrow with the same 3 centimeters has an FOC of 5 percent. Compare arrows of different lengths with care, and always work out the percentage rather than the distance.
Recording your results
It can be helpful to write down the length, the balance point, the point weight and the FOC of each arrow set, along with how it flew. Over time, the record shows which combinations work best with your bow. Keep your notes in the same units each time so that you can compare them.
Common mistakes
- Measuring from the wrong end. Measure from the throat of the nock.
- Mixing units. Use the same units for both lengths.
- Weighing the arrow without its point. Fit the point first.
- Changing too much at once. Change one thing and test.
What next
Use this often? Add Arrow FOC to your Home screen.
Frequently asked questions
What is an arrow FOC calculator?
A tool that works out the front of center of an arrow, which shows how far its balance point is ahead of the middle.
How do you calculate FOC?
Distance to the balance point minus half the arrow length, divided by the arrow length, times 100.
What is a good FOC for a hunting arrow?
Easton Archery recommends a minimum of 10 to 15 percent, for hunting and target arrows alike. Many bowhunters aim higher.
How do I find the balance point?
Rest the arrow on a narrow edge until it balances, then measure from the throat of the nock to that point.
How can I change my arrow's FOC?
Adding weight to the point or insert is the usual way. A heavier point needs a stiffer spine, so test any change with your own bow.
Was this tool helpful?
What went wrong?
We only receive the reason you pick, never what you typed into the tool.
Thanks for your feedback.