Saved

Press the star next to a tool's name to save it.

All my tools

Draw Length Calculator

Use this draw length calculator to estimate your archery draw length from your wingspan: divide the wingspan by 2.5 and round to the nearest half inch.

Restored your last values ·

Stand upright with your arms spread out to the sides and have someone measure your wingspan between the fingertips of your middle fingers. Enter it here. The calculator divides it by 2.5 and rounds to the nearest half inch, the usual step for bow adjustments.

Everything is worked out in your browser. Nothing you type is sent anywhere.

–

–

Enter your wingspan and press Find draw length.

See full result

A draw length calculator estimates the right draw length for a bow from your wingspan. Measure how far you can stretch your arms, enter it, and the calculator gives your draw length in inches, rounded to the nearest half inch, and in centimetres. It runs in your browser and nothing you enter is sent anywhere.

What draw length is

Draw length is how far back you pull the string at full draw. The Wikipedia page on compound bows gives the standard draw length as the distance from the string at full draw to the lowest point on the grip, plus 1.75 inches. A bow that is set to the right draw length for you lets you anchor properly. The Bowhunter magazine article says that if your draw length is too short, you will be forced to hunch up to see through the peep sight, and if it is too long, you will be forced to stretch and strain to get the string back and hold it there.

How to use the draw length calculator

  1. Stand up straight and spread your arms out wide.
  2. Have a helper measure your wingspan between the fingertips of your middle fingers.
  3. Enter the measurement in inches or centimetres.
  4. Press Find draw length.

The rule

The Bowhunter article gives the method: measure your wingspan between the fingertips of your middle fingers, then divide that measurement by 2.5. It says that the result of this simple exercise should get you very close to your correct draw length, though some fine-tuning may still be needed. The calculator applies exactly this rule. If you enter centimetres, it converts to inches first, since the divisor is given for inches.

Worked example

A person with a wingspan of 70 inches divides 70 by 2.5, which gives a draw length of 28 inches. In centimetres, that is about 71.1. A wingspan of 71.6 inches gives 28.64 inches, which rounds to 28.5 inches. A wingspan of 178 centimetres is 70.08 inches, which gives 28.03 inches, or 28 inches to the nearest half inch.

Why the calculator rounds to a half inch

The article notes that most bows allow the draw length to be adjusted in half-inch increments. If your bow has a rotating module, changing the draw length can typically be done by removing a couple of screws, turning the module to the new setting and putting the screws back. If the bow has cams made for a specific draw length, you may need to order new cam modules from a dealer. That is why the calculator gives the exact figure and the nearest half inch, so you can see both.

Fine-tuning

The article says that you want the draw length that lets you pull the string back comfortably, with good posture, your head held up straight and your holding elbow in line with and pointing straight away from the arrow. It suggests asking a friend to stand behind you at full draw and check your alignment. For adjustments of less than half an inch, it says you can use the limb or cable stops on your cams, or change the length of your nocking loop: a longer loop gives a little more draw length and a shorter one a little less.

Using the result

Use the half-inch figure as the setting to try first on a bow that allows that adjustment. Take a few shots, and watch your form. If it feels hunched or strained, change it a half inch and try again. Even small adjustments can make a big difference to your shooting consistency, according to the article. If you share a bow, or buy a used one, check the setting before you shoot, since it may be set for someone else.

Reading the result

The calculator shows three figures: the draw length rounded to the nearest half inch, the exact result and the draw length in centimetres. Use the first as the setting to try on your bow. The exact figure shows how far the result was from the rounded one: if it is 28.64, a setting of 28.5 is very close. The centimetre figure is handy if your bow or your dealer works in metric.

Taking a good measurement

The measurement is the key to the result, so take it with care. The article says to stand upright, spread your arms out to the side and have someone measure the wingspan between the fingertips of your middle fingers. Use a tape measure and keep your arms level and straight. Take the measurement twice, and if the figures differ, use the average. A small error in the wingspan makes a smaller error in the result, because the figure is divided by 2.5: a one-inch difference in wingspan changes the draw length by only 0.4 inch.

Draw length and your bow

Once you know your draw length, check what your bow is set to. Many compound bows can be adjusted in steps, and some need modules made for a particular length. If you buy a used bow, or you share one with friends or family, check the setting, because the article says it is easy for people to neglect. A bow that is set to someone else's draw length will make it hard to shoot consistently, whatever your form.

When the rule does not fit

The wingspan rule is a general guide. People have different proportions, and a few will find that their best draw length is a little more or less than the figure. That is why the article calls the result very close to the correct draw length and says that fine-tuning may still be needed. Treat the figure as the start of a process, and check your form at full draw, ideally with a coach or an archery shop to watch.

Common mistakes

  • Measuring with arms bent. Spread them straight out to the sides.
  • Measuring to the wrist. Measure to the fingertips of the middle fingers.
  • Treating the result as exact. It is a starting point to fine-tune.
  • Skipping the check at full draw. Your elbow should line up with the arrow.

What next

Use this often? Add Draw Length to your Home screen.

Frequently asked questions

What is a draw length calculator?

A tool that estimates the right draw length for a bow from your wingspan.

How do you calculate draw length?

Measure your wingspan between the fingertips of your middle fingers, then divide it by 2.5.

What is the draw length for a 70-inch wingspan?

70 divided by 2.5 is 28 inches.

Why round to the nearest half inch?

Most bows adjust draw length in half-inch increments, according to the Bowhunter article.

How do I check my draw length?

At full draw, your holding elbow should be in line with the arrow and your posture upright. An archery shop can also check it.

What went wrong?

We only receive the reason you pick, never what you typed into the tool.

Thanks for your feedback.

More Fun & Lifestyle Tools