A Bruce protocol METs calculator turns your time on the Bruce treadmill test into METs, which measure how hard your body worked, and into an estimate of your VO2 max. Enter your sex, age and the time you lasted, and the calculator gives the METs, the VO2 max and your estimated maximum heart rate. It uses the stage table and the oxygen formulas on Wikipedia's Bruce protocol page [1], the MET definition [2] and a published maximum heart rate formula [3]. It runs in your browser.
How to use the Bruce protocol METs calculator
- Choose female or male.
- Enter your age.
- Enter the time, in minutes, that you lasted on the treadmill test.
- Press Work out the METs.
What the Bruce protocol is
The Bruce protocol is a treadmill exercise test that is often used to check the fitness of the heart. The treadmill speed and slope rise in stages, and you keep going until you must stop. Wikipedia's table lists seven stages of three minutes each [1]: the first is a slope of 10 percent at 1.7 miles per hour, the second 12 percent at 2.5, the third 14 percent at 3.4, the fourth 16 percent at 4.2, the fifth 18 percent at 5.0, the sixth 20 percent at 5.5 and the seventh 22 percent at 6.0 miles per hour. The work rises from about 3 METs in the first stage to about 21 in the seventh [1]. The longer you last, the fitter you are.
The formulas
The maximum heart rate is 192 minus 0.007 times the square of your age, the nonlinear formula from an Oakland University study listed on Wikipedia [3]. For women, the oxygen use in milliliters per kilogram per minute is 4.38 times the time in minutes minus 3.9, which Wikipedia lists for young women [1]. For men, the calculator uses 14.8 minus 1.379 times the time, plus 0.451 times the square of the time, minus 0.012 times the cube of the time. Wikipedia prints the first number as 14.76, so our figure is rounded [1]. The METs are the oxygen use divided by 3.5 [2]. In our own worked example, a 30-year-old woman who lasts 12.5 minutes has a maximum heart rate of about 185.7 beats per minute, an oxygen use of about 50.85, and about 14.53 METs.
What METs are
A MET is a multiple of your resting energy use, where one MET is the energy that you use sitting quietly [2]. A task of 5 METs takes five times as much energy as rest. The 3.5 figure is a convention, and Wikipedia notes that it overestimates real resting oxygen use by roughly 20 to 30 percent on average [2]. A higher result than your earlier ones means better fitness, and a result that is much lower than you expect can be worth discussing with a doctor.
Important cautions
The test pushes your body to a high effort. It is normally done in a clinic or a lab with someone watching your heart and blood pressure, especially for people with heart disease risks. The calculator is only for working out numbers from a time that you already have, for example from a test that you did with a professional, and it does not tell you whether to do the test. The formulas are for the standard Bruce protocol and not the modified one, which starts more gently, so they do not apply to the modified version.
Reading your result
Use your METs as a way to track change over time, and compare results from the same test done in the same way. If you improve your time after a few months of training, the METs and the VO2 max will go up. Do not compare yourself with people of a different age or sex without care, since the formulas are different for women and men.
Worked example for a man
A 40-year-old man lasts 12 minutes on the treadmill. His estimated maximum heart rate is 192 minus 0.007 times 1,600, which is 180.8 beats per minute. His oxygen use is 14.8 minus 16.548, plus 64.944 minus 20.736, which is about 42.46, and dividing by 3.5 gives about 12.1 METs. Compare that figure only with his own earlier results from the same test. The numbers are our own illustration of the formula.
What affects the time
The time that you last depends on your fitness, but also on your weight, your motivation, how well you slept, the temperature of the room, and whether you have eaten or taken any medicine. For this reason, a single result should not be over-read. If you repeat the test, try to do so in the same conditions, so that you can compare the results.
Talking to a doctor
If you use this calculator because of a medical test, ask the doctor or technician who ran it how they read the results. They have your history and the findings from the test, such as your heart rhythm and blood pressure, which matter much more than the METs alone. The calculator only turns the time into a number and cannot say whether the number is a cause for concern.
Common mistakes
- Using the time in seconds. Enter minutes, with decimals.
- Using the modified protocol. The formulas are for the standard test.
- Choosing the wrong sex. The formulas differ.
- Doing the test alone. It should be supervised.
What next
Use this often? Add Bruce Protoc to your Home screen.
Frequently asked questions
What is a Bruce protocol METs calculator?
A tool that converts the time you lasted on the Bruce treadmill test into METs and an estimated VO2 max.
What formula does it use?
For women, VO2 = 4.38 times the time minus 3.9. For men, a cubic formula in the time. METs are VO2 divided by 3.5.
What is a MET?
A unit of energy use where one MET is the energy used at rest. Ten METs is ten times the resting rate.
Is this the modified Bruce protocol?
No. The formulas are for the standard Bruce protocol, which starts at a slope of 10 percent at 1.7 miles per hour.
Should I do the Bruce test on my own?
No. It is a stress test that should be done under supervision, particularly if you have a heart condition.
Sources
Was this tool helpful?
What went wrong?
We only receive the reason you pick, never what you typed into the tool.
Thanks for your feedback.